LightBurn 0.8.03 – A little needed cleanup

Home Forums Software LightBurn Lightburn Software Releases LightBurn 0.8.03 – A little needed cleanup

This topic contains 0 replies, has 1 voice, and was last updated by  LaserLarry Admin 2 weeks, 4 days ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #2770

    LaserLarry Admin
    Keymaster

    LightBurn 0.8.03 – A little needed cleanup
    by LightBurn Software August 30, 2018
    Our last release was quite large, and a few changes slipped in at the last minute that should’ve been tested more.  This release is a small patch to address those problems. Specifically:

    Fixed a crash in the new Scan by Groups option
    Fixed a scale bug when saving / copying N-sided regular polygons
    Fixed an issue with Scan+Cut when using “Scan shapes individually” or “Scan by groups” where holes weren’t properly detected
    For good measure, we also fixed these, which have been around a while longer:

    Fixed relative-mode GCode generation for rotary
    Fixed a bug where foreign language settings were causing all cuts to use “Current position”
    As always, use the in-app Check for Updates, or grab it from our downloads page.

    Thanks for supporting LightBurn!

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.