02/06/2018 at 8:28 AM #1419
My name is Travis and I have an electronics hobby addiction.
I currently have a K40 with C3d upgrade and an eleksMaker 2.5w A5 laser. My Tevo Tarantula 3d printer has been making upgrade parts for both lately.
I’ve pulled the bed out of the k40 and replaced it with a 4″ scissor lab jack, cut down the exhaust vent to get the most area out of the stock setup.
I’ve added a drag chain that currently has my air assist tube. I have another mod in progress that will add positioning diode laser cross hairs (I tried a 3d print that dropped a red diode laser in front of the primary mirror when you open the lid, but I can’t seem to get it to line up properly, so, I’ve printed something else that will ride on the gantry).
I use LW3 running on a nanopi neo for the eleksMaker and was running LW4 on the K40, but I’ve since switched over to LightBurn.
One question: Is there plans to support tapatalk for the forums?
You must be logged in to reply to this topic.