I have been having a struggle to get laserweb to cut/engrave where I expect it to. So far I think I have discovered that I must refresh the page after changing the offset. If this is incorrect does anyone know the correct procedure, it would save my having to reload the file and Laserweb each time I make a change.
It is not necessary to do a refresh of the page after you alter the offset in LaserWeb.
You need to head to the CAM tab (on the left menu) & then alter your offset & then click the "Generate G-Code" button at the top of the CAM tab again.
It will in effect, re-create the G-Code, utilising the new offset positions that you have set.
I have yet to work out multi-file jobs as yet in LaserWeb, so this is my knowledge for a single file job.
Scott Marshall: 5
Bruce G: 3
eric bradley: 1
Guest Posters: 1
Most Users Ever Online: 15
Currently Browsing this Page: